Tactical Smock jacket with a well-developed pocket system. After 2, they were located in the area of the chest and below the waist. These are closed with button tabs and additionally with a zipper on the sides. The pockets are equipped with plastic D-rings inside. Further pockets are placed on the sleeves, 2 inside the jacket and 1 big one at the back. An additional advantage are foam pads, which are placed on the elbows.
Made of a combination of polyester and cotton, additionally reinforced with Rip-Stop mesh. Smock model is fastened with a two-way zip and an additional patch of buttons, which is designed to protect the body against the wind. The waist can be adjusted by means of a string. The hood, which is an integral part of the whole, can also be adjusted. The hood's roof is reinforced with wire.
|Size||Total Length (cm/in)||Chest Circumference (cm/in)||Sleeve Lenght - from armpit to cuff (cm/in)|
|S||74 cm (29,1")||110 cm (43,3")||57 cm (22,4")|
|M||77 cm (30,3")||124 cm (48,8")||67 cm (26,4")|
|L||83 cm (32,7")||130 cm (51,1")||68 cm (26,8")|
|XL||83 cm (32,7")||134 cm (52,8")||70 cm (27,6")|
|XXL||90 cm (35,4")||142 cm (55,9")||70 cm (27,6")|
|3XL||92 cm (36,2")||152 cm (59,8")||72 cm (28,4")|
INSTRUCTIONS: HOW TO MEASURE
Please read the following instructions to be sure you buy a product that will fit well.
Place a garment that fits you well on a flat, even surface (e.g. table, floor, bed) and take its measurements.
Remember to measure without stretching the material!
1. Total length
Place the garment facing surface and measure the length in a straight line from collar seam to the bottom of the measured item.
2. Chest measurements
Place the back of the garment on the surface and measure the width between the seams in the armpits. Multiply this value twice to get the chest measurements.
3. Sleeve length from armpit
Place the back of the garment on the surface and measure the length from the armpit seam to the end of the sleeve cuff.
What if you are between two sizes? It's easy. If you prefer more fitted clothes, choose a smaller size. If you prefer to be a little looser, go for the larger size.
THE TOLERANCE FOR THE DIMENSIONS GIVEN IN THE TABLE IS +/- 2 CM.